HP 7000 dl Router Series Guia do Utilizador descarregar pdf (Página 440)

SROS Command Line Interface Reference Guide Ethernet Interface Configuration Command Set

bandwidth <value>

Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.

This value is used in cost calculations. Use the no form of this command to restore the default values.

Syntax Description

<value> Enter bandwidth in kbps.

Default Values

To view default values use the show interfaces command.

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: Ethernet, Frame Relay virtual sub-interfaces (fr 1.20),

virtual PPP (ppp 1), and loopback interfaces

Functional Notes

The bandwidth command is an informational value that is communicated to the higher-level protocols to

be used in cost calculations. This is a routing parameter only and does not affect the physical interface.

Usage Examples

The following example sets bandwidth of the Ethernet 0/1 interface to 10 Mbps:

(config)#interface eth 0/1

(config-eth 0/1)#bandwidth 10000

Sem comentários

HP 7000 dl Router Series Guia do Utilizador Página 440