HP 7000 dl Router Series Guia do Utilizador descarregar pdf (Página 568)

SROS Command Line Interface Reference Guide Frame Relay Interface Config Command Set

bandwidth <value>

Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.

This value is used in cost calculations. Use the no form of this command to restore the default values.

Syntax Description

<value> Enter bandwidth in kbps.

Default Values

No default value is necessary for this command.

Command Modes

(config-interface)# Interface Configuration Mode

Functional Notes

The bandwidth command is an informational value that is communicated to the higher-level protocols to

be used in cost calculations. This is a routing parameter only and does not affect the physical interface.

Usage Examples

The following example sets bandwidth of the Frame Relay interface to 10 Mbps:

(config)#interface frame-relay 1

(config-fr 1)#bandwidth 10000

Sem comentários

HP 7000 dl Router Series Guia do Utilizador Página 568