HP 7000 dl Router Series Guia do Utilizador descarregar pdf (Página 816)

100

101

SROS Command Line Interface Reference Guide HDLC Command Set

bandwidth <value>

Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.

This value is used in cost calculations. Use the no form of this command to restore the default values.

Syntax Description

<value> Enter bandwidth in kbps.

Default Values

To view default values use the show interfaces command.

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), virtual

HDLC interfaces (hdlc 1), virtual Frame Relay sub-interfaces (fr 1.20), tunnel

interfaces (tunnel 1), and VLAN interface (vlan 1).

Functional Notes

The bandwidth command is an informational value that is communicated to the higher-level protocols to

be used in cost calculations. This is a routing parameter only and does not affect the physical interface.

Usage Examples

The following example sets bandwidth of the HDLC interface to 10 Mbps:

(config)#interface hdlc 1

(config-hdlc 1)#bandwidth 10000

1 2 ... 811 812 813 814 815 816 817 818 819 820 821 ... 940 941

Comentários a estes Manuais

Sem comentários

HP 7000 dl Router Series Guia do Utilizador Página 816

Comentários a estes Manuais

Manuais e produtos relacionados com Redes HP 7000 dl Router Series