HP B-series Embedded Switches Manual do Utilizador descarregar pdf (Página 104)

Basic Security in FOS

104 Fabric OS Procedures Version 3.1.x/4.1.x User Guide

5. Enter passwd command at the prompt.

Note: This command is specific to the Boot PROM password when entered from the

boot interface.

6. Enter the Boot PROM password at the prompt, then re-enter when prompted.

The password must be 8 alphanumeric characters (any additional characters

are not recorded).

7. Record this password for future use.

8. Enter the saveenv command to save the new password.

9. Reboot the switch by entering the reset command.

Traffic flow resumes when the switch finishes rebooting.

Setting the Boot PROM Password Only (Core Switch 2/64)

The option of setting the Boot PROM password only is available on a SAN Switch

2/32 and Core Switch 2/64, but is not recommended. See “Setting Both the Boot

PROM and Recovery Passwords (Core Switch 2/64)” on page 101.

On the Core Switch 2/64, the suggested procedure is to set the password on the

Standby CP, then failover; then set the password on the previously Active (now

Standby) CP to minimize disruption to fabric.

The Boot PROM and Recovery passwords must be set for each CP card on a Core

Switch 2/64 switch.

Note: Setting the Boot PROM password requires accessing the boot prompt, which

stops traffic flow through the switch until the switch is rebooted.

1. Determine the active CP card by opening a telnet session to either CP card,

logging in as Admin, and entering the hashow command.

2. Log in to the active CP card by serial or telnet and enter the hadisable

command to prevent failover during the remaining steps.

3. Create a serial connection to the standby CP card as described in “Setting the

Boot PROM Password Only (SAN Switch 2/32)” on page 102.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 269 270

Sem comentários

HP B-series Embedded Switches Manual do Utilizador Página 104