HP B-series Embedded Switches Manual do Utilizador descarregar pdf (Página 22)

Initial Configuration

22 Fabric OS Procedures Version 3.1.x/4.1.x User Guide

Changing the Admin Password in v3.1 Firmware

For security reasons, the first time you log into the Fabric OS you are requested to

change the system password. The following procedure applies specifically to v3.1.

To change the admin password:

1. Log into the switch as the admin user.

2. Enter the passwd admin command. In v3.0.1 you must specify the user

level when modifying the password.

Note: Quotation marks must be used for complete initialization of this command.

Example:

3. An interactive session is started where you can change the admin user name

and the password. If you want to change the admin user name, at the New

username prompt, enter a new name for the admin user. Click Return without

changing the value to leave it as is. You can change the password of the admin

user without changing the user name.

4. At the Old password prompt, enter the old password.

5. At the New password prompt, enter the new password. The new password

must be at least 8 characters in length.

6. At the Re-enter new password prompt, enter the new password

exactly as entered in the previous prompt. Press the Enter key to save the new

password to the firmware.

Example:

switch:admin> passwd "admin"

New username [admin]:

Old password: xxxxxxxx

New password: xxxxxxxx

Re-enter new password: xxxxxxxx

Saving passwd...done.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 269 270

Sem comentários

HP B-series Embedded Switches Manual do Utilizador Página 22