HP B-series Embedded Switches Manual do Utilizador descarregar pdf (Página 154)

Updating Switches to the Core PID Addressing

154 Fabric OS Procedures Version 3.1.x/4.1.x User Guide

Procedures for Updating the Core PID Format

The following sections present basic procedures for update the Core PID format

and detailed procedures for HP/UX and AIX.

Basic Update Procedures

This process should be executed as part of the overall online or offline update

process. However, it may be implemented in a stand-alone manner on a

non-production fabric on a switch that has not yet joined a fabric.

1. Ensure that all switches in the fabric are running Fabric OS versions that

support the new addressing mode. The recommended firmware versions are:

2.6.0c or later for StorageWorks 1 Gb SAN switches, 3.0.2g or later for SAN

Switch 2/8 EL and SAN Switch 2/16 switches, and 4.0.2x or later for SAN

Switch 2/32 and Core Switch 2/64 switches.

Note: All switches running any version of Fabric OS 4.x are shipped with the Core

Switch PID Format enabled, so it is not necessary to perform the PID format change on

these switches.

2. Telnet into one of the switches in the fabric.

3. Disable the switch by entering the switchdisable command.

4. Enter the configure command (the configure prompts display

sequentially).

5. Enter “y” after the “Fabric parameters” prompt.

6. Enter “1” at the “Core Switch PID Format” prompt.

7. Complete the remaining prompts or press Ctrl+D to accept the remaining

settings without completing all the prompts.

8. Repeat steps 2 through 7 for the remaining switches in the fabric.

9. Re-enable the switch by entering the switchenable command.

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 269 270

Sem comentários

HP B-series Embedded Switches Manual do Utilizador Página 154