HP B-series Embedded Switches Manual do Utilizador descarregar pdf (Página 29)

Initial Configuration

29Fabric OS Procedures Version 3.1.x/4.1.x User Guide

Configuration Requirement

■ The Core PID must be enabled on all 2.6.0c + and 3.0.2g + switches. See

(Optional) Enabling Core PID Addressing.

(Optional) Enabling Core PID Addressing

To enable Core PID addressing on 2.6.0c or 3.0.2g switches for the purpose of

mixing in to a 4.x.x fabric:

1. Telnet into the switch.

2. Log into the switch as admin.

3. Disable the switch by entering the switchdisable command.

4. Enter the configure command (the configure prompts display

sequentially).

5. Enter “y” after the “Fabric parameters” prompt. Be sure to use the same

configuration parameters as the rest of your fabric.

6. Enter “1” at the “Core Switch PID Format” prompt. This enables the Core

PID addressing, and allows the non-4.x switch to merge into a 4.x fabric.

7. Complete the remaining prompts or press Ctrl+D to accept the remaining

settings without completing all the prompts.

8. Be sure to use the same configuration parameters as the rest of your fabric.

9. Repeat steps 1 through 4 for all 2.6.0c or 3.0.2g switches that you want to

incorporate into the mixed fabric.

Considering Additional Fabric Configurations

In addition to the fabric configurations set through the configure command,

additional configurations can be set.

The following are some additional configurations to consider:

Set Routing See Routing on page 65.

Track Changes See Tracking Switch Changes on page 63.

Status Policies See Switch Status Policies on page 58.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 269 270

Sem comentários

HP B-series Embedded Switches Manual do Utilizador Página 29