HP B-series Embedded Switches Manual do Utilizador descarregar pdf (Página 105)

Basic Security in FOS

105Fabric OS Procedures Version 3.1.x/4.1.x User Guide

4. Reboot the standby CP card by pressing the yellow ejector buttons at top and

bottom of the CP card, then pressing both ejector handles back towards the

switch to lock the card back into the slot. This causes the card to reset.

5. Press ESC within four seconds after the message Press escape

within 4 seconds... displays.

The following options are available:

1) Start system.

2) Recovery password.

3) Enter command shell.

6. Enter “3” at the prompt to enter the command shell.

7. Enter passwd command at the prompt.

Note: This command is specific to the Boot PROM password when entered from the

boot interface.

8. Enter the Boot PROM password at the prompt, then re-enter when prompted.

The password must be 8 alphanumeric characters (any additional characters

are not recorded).

9. Record this password for future use.

10. Enter the saveenv command to save the new password.

11. Reboot the standby CP card by entering the reset command.

12. Failover the active CP card by opening a telnet session to the Active CP card,

logging in as Admin, and entering the hafailover command.

Traffic resumes flowing through the newly active CP card once it has

completed rebooting.

13. Connect the serial cable to the serial port on the new standby CP card

(previous active CP card).

14. Repeat step 3 through step 11 for the new standby CP card (each CP card has

a separate Boot PROM password).

15. Log in to the active CP card by serial or telnet and enter the haenable

command to restore high availability.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 269 270

Sem comentários

HP B-series Embedded Switches Manual do Utilizador Página 105