HP d212 Manual do Utilizador Página 94
- Página / 177
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
FMS-D212-725-1
Page 3-18
• COPYRIGHT © 2007 BY DART AEROSPACE LTD •
This document is private and confidential and is supplied on the express condition that it is not to be used for any
purpose or copied or communicated to any other person without written permission from Dart Aerospace Ltd.
Revision:
D
TC Approved Date: 08.12.17
3.5.5 Fixed Pitch Failure in Flight
If tail rotor fixed pitch failure occurs during climb (left pedal applied), cruise
(approximately neutral pedals), and descent (right pedal applied), a descent
and landing can be effected safely by use of power and throttle changes.
Procedures:
If helicopter is in a trimmed condition when malfunction is discovered, engine
power and airspeed should be noted and the helicopter flown to a suitable
landing area.
Combinations of ENG TORQUE, ROTOR RPM (N
R
), and AIRSPEED will
correct or aggravate yaw attitude and these should be adjusted as required
to control yaw during landing.
Right Pedal Locked Forward of Neutral:
Power should be reduced and ENG RPM (N
2
) maintained within green arc.
This will help streamline helicopter in flight. Right turns are easier than left
turns. AIRSPEED should be maintained at or above 60 KIAS.
Execute a normal to steep approach adjusting power as necessary to
minimize or prevent right yaw. Maintain ENG RPM (N
2
) and an AIRSPEED
of 60 KIAS during initial part of approach.
At 60 to 75 feet AGL and when landing area can be made, start a slow
deceleration to arrive at intended landing point with AIRSPEED at about 25
KIAS.
At 2 to 5 feet AGL, slowly reduce throttle to overcome yaw effect and allow
helicopter to settle. When aligned with landing area, allow helicopter to
touchdown.
After ground contact, use collective and throttle as necessary to maintain
alignment with landing strip, and to minimize forward speed. If helicopter
starts to turn, move cyclic as necessary to follow turn until helicopter comes
- Shepherd 1
- Page Intro-3 3
- Revisions 4
- Unapproved Date: 07.11.30 5
- General Information 5
- Terminology 6
- Section 1 10
- 1.4 Flight Crew 14
- 1.5 Configuration 14
- 1.5.3 Doors Open/Removed 15
- 1.5.4 Passengers 15
- TC Approved Date: 10.05.12 16
- 1.5.5 Cargo 18
- 1.5.5.2 Cargo Compartment 18
- 1.6.1 Weight 19
- 1.6.2 Center of Gravity 20
- 1.7 Airspeed 21
- 10.05.12 22
- 1.8 Altitude 23
- 1.9 Maneuvering 23
- TC Approved Date: 08.06.12 25
- 1.11 Ambient Temperature 26
- 1.12 Electrical 27
- 1.13 Power Plant 28
- 1.13.2 Power Turbine (N 29
- Limitations (T5317A Only) 29
- 1.13.6 Fuel Pressure 30
- 1.14 Transmission 31
- 1.15 Rotor 32
- 1.16 Hydraulic 32
- 1.17 Fuel and Oil 33
- 1.18 Rotor Brake 34
- 1.19 Heater 34
- 1.20 Additional Placards 35
- 1.21 Instrument Markings 36
- Section 2 45
- 2.3 Preflight Check 48
- 2.3.1 Before Exterior Check 49
- 2.3.2 Exterior Check 51
- 2.4.1 Pre-start Check 57
- 2.5 Engine Start 63
- 2.6 Systems Check 65
- 2.6.3 Engine Fuel Control 66
- 2.6.4 Rpm Control 67
- 2.6.5 Anti-ice Check 67
- 2.7 Before Takeoff 71
- 2.8 Takeoff 72
- 2.9 In-Flight Operation 73
- 2.10 Descent and Landing 73
- 2.11 After Landing 74
- 2.12 Engine Shutdown 74
- 2.13 Post Flight Check 76
- Section 3 77
- 08.12.17 78
- 3.3 Engine 80
- 3.3.4 Engine Underspeed 84
- 3.3.5 Engine Overspeed 85
- 3.4 Fire 87
- 3.4.2 Cabin Smoke or Fumes 89
- 3.5 Tail Rotor 90
- TC Approved Date: 08.12.17 91
- 3.6 Hydraulic System 96
- 3.7 Electrical System 97
- 3.8 Fuel System 97
- 3.9 Communications System 99
- 3.10 Cabin Heater 99
- 3.10.2 Heater Overheat 100
- Revision: 101
- TC Approved Date: 13.08.09 101
- 13.08.09 102
- TC Approved Date: 09.08.10 103
- IF on ground: ENGINE 105
- Section 4 108
- 08.06.12 109
- FMS-D212-725-1 113
- Page 4-6 113
- 4.3 Power Assurance Checks 114
- Page 4-10 117
- 4.4 Hover Ceiling Charts 118
- 4.5 Takeoff Distance 118
- 4.6 Rate of Climb – Maximum 118
- 4.7 Landing Distance 119
- 4.8 Height Velocity 119
- Hover Ceiling 122
- Takeoff Distance 130
- Rate of Climb – Maximum 142
- Landing Distance 144
- TC Approved Date: 07.06.01 151
- Autorotative Glide Distance 152
- 4,000 feet 153
- Height Velocity Chart 154
- Section 5 155
- 07.06.01 156
- 5.4 Doors Open or Removed 158
- 5.7 Fuel Loading 159
- 5.7.1 Computation of CG 160
- 5.7.2 Sample Loading Problem 160
- Unapproved Date: 07.06.01 161
Manuais e produtos relacionados com Barebones PC/estação de trabalho HP d212
(18 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.053 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais