HP 690n Guia do Utilizador descarregar pdf (Página 142)

Troubleshooting wireless print servers

Unable to communicate during initial setup

If you use wireless communications to set up the print server, verify the following:

●

Your wireless computer is configured to match the default wireless network settings on the

HP Jetdirect print server:

❑

Communication Mode: Ad Hoc

❑

Network Name (SSID): hpsetup

❑

Encryption (WEP): <Disabled>

NOTE: The network name (SSID) is case-sensitive. Be sure to specify “hpsetup” using lowercase

characters.

●

The HP Jetdirect print server is turned on and operating properly (print the configuration page).

●

You are within range of the HP Jetdirect print server.

●

There are fewer than six devices total on the ad hoc network (with SSID “hpsetup”).

●

There is no access point in the vicinity that is configured with an SSID of “hpsetup”.

●

Multiple print servers are not being configured at the same time. If there are multiple print servers,

turn all off except the one you want to configure.

Unable to communicate after initial setup

If you have successfully configured the HP Jetdirect wireless print server with a network connection to

your network, but your network computers are unable to communicate with the printer (including a ping

command), try the following:

●

Print an HP Jetdirect configuration page and verify all configuration settings for your network.

Common errors include incorrect entries for the following items:

❑

Communication Mode (Ad Hoc or Infrastructure)

❑

Network Name (SSID), which is case-sensitive

❑

Authentication method

❑

Encryption type, encryption key entries, or the specified transmit key

❑

IP address

❑

Basic service set identifier (BSSID), which distinguishes one wireless LAN from another even

though they have the same SSID

●

Verify that the printer is within range of the network. See “

Improving reception and performance

on page 134” in this chapter.

●

Use a wireless PC and its utilities to confirm the signal strength at the printer's location. The

detected signal strength should be similar for the print server, as indicated on the HP Jetdirect

configuration page.

132 Chapter 7 Troubleshoot the HP Jetdirect print server

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 205 206

Comentários a estes Manuais

Sem comentários

HP 690n Guia do Utilizador Página 142

Comentários a estes Manuais

Manuais e produtos relacionados com Redes HP 690n