HP 690n Guia do Utilizador descarregar pdf (Página 35)

Example HP Jetdirect TFTP configuration file

# Allow subnet 192.168.10.0 access

allow: 192.168.10.0255.255.255.0

# Disable Telnet

telnet-config: 0

# Enable the embedded Web server

ews-config: 1

# Detect SNMP unauthorized usage

auth-trap: on

# Send traps to 192.168.10.1

trap-dest: 192.168.10.1

# Specify the Set Community Name

set-cmnty-name: 1homer2

# End of File

Set allow to enable subnet 192.168.10.0 with access to the printer.

This specifies a host or network of hosts that can connect to the print

server. Add up to 10 entries using TFTP, Telnet, or the HP Embedded

Web Server. You can also specify single IP addresses for specific

systems. The following list describes the example TFTP configuration

file settings:

telnet-config Set to zero (0). Cannot use Telnet.

ews-config Set to one (1). Use the HP Embedded Web Server.

auth-trap Set to on. Send SNMP authentication traps.

trap-dest IP address of the system to send SNMP traps to.

set-cmnt-name Community name required in SNMP Set

commands.

This table describes the TFTP command parameters supported by HP Jetdirect print servers. (Optional

commands for the same function are shown in parentheses.)

Table 3-2 TFTP configuration file parameters

General

passwd: (or passwd-admin:)

Administrator's password to control access to HP Jetdirect print server configuration parameters using Telnet, HP Web

Jetadmin, or the HP Embedded Web Server. Enter up to 16 alphanumeric characters. Clear the password with a cold

reset.

sys-location: (or host-location:, location:)

Physical location of the printer (SNMP sysLocation object). Enter up to 64 alphanumeric characters. The default location is

undefined.

sys-contact: (or host-contact:, contact:)

Name of the network or device administrator (SNMP sysContact object) who administers or services the printer. Enter up

to 64 alphanumeric characters. The default contact is undefined.

IPv4 configuration

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 205 206

Sem comentários

HP 690n Guia do Utilizador Página 35