
Table C-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item Sub-menu item Sub-menu item Values and Description
Execute No (default): Do not run the selected tests.
Yes: Run the selected tests.
Ping Test Test network communications. Sends link-level packets
to a remote network host, then waits for an
appropriate response.
Dest Type Target device is an IPv4 or IPv6 node.
Dest IPv4 The IPv4 address.
Dest IPv6 The IPv6 address.
Packet Size Size of each packet, in bytes, sent to the remote host.
The minimum is 64 (default) and the maximum is
2048.
Timeout Length of time, in seconds, to wait for a response from
the remote host. The default is 1 and the maximum is
100.
Count Number of ping test packets to send. Select a value
from 1 to 100. Enter zero (0) to run the test
continuously.
Print Results Print the test results (if not running continuously).
Yes: Print the results.
No (default): Do not print the results.
Execute Run the ping test.
No (default): Do not run the test.
Yes: Run the test
Ping Results View the ping test status and results, using the control
panel display.
Packets Sent Number of packets (0 - 65535) sent to the remote host
since the most recent test was initiated or completed.
Packets Received Number of packets (0 - 65535) received from the
remote host since the most recent test was initiated or
completed.
Percent Lost Percent of sent ping test packets without a response
from the remote host since the most recent test was
initiated or completed.
RTT Min Minimum detected round trip time (RTT), from 0 to
4096 milliseconds, for packet transmission and
response.
RTT Max Shows the maximum detected round trip time (RTT),
from 0 to 4096 milliseconds, for packet transmission
and response.
Graphical control panel menus
183
Comentários a estes Manuais