HP 690n Guia do Utilizador descarregar pdf (Página 96)

Table 4-13 Miscellaneous Settings (continued)

Item Description

IPP Printing

Use IPP on the HP Jetdirect print server. If the printer is properly connected and accessible,

IPP allows printing to this device over the Internet (or intranet). A properly configured IPP

client system is also required. For information on IPP client software, see

HP software

solutions summary on page 7.

HP XML Services

Allow access by HP Web service applications to XML-based data on the HP Jetdirect print

server.

Certificate Mgmt Service

Allow HP Web Jetadmin to access and service your certificate configuration.

Web Services Print

Use the Microsoft Web Services for Devices (WSD) Print services supported on the

HP Jetdirect print server.

WS-Discovery

Use the Microsoft Web Services Dynamic Discovery (WS Discovery) protocols on the print

server.

LLMNR

Indicates whether link local multicast name resolution (LLMNR) requests are responded to

over IPv4 and IPv6.

Link settings

(For wired 10/100/1000T Ethernet) Set the print server's link speed and communication

mode. The available selections depend on the print server model.

CAUTION: If you change the link setting, network communications with the print server

and network device might be lost.

●

AUTO (default) Use auto-negotiation to configure itself with the highest link speed

and communication mode allowed. If auto-negotiation fails, either 100TX HALF or

10TX HALF is set, depending on the detected link speed of the hub/switch port. (A

1000T half-duplex selection is not supported.)

● 10T-Full 10 Mbps, full-duplex operation.

●

10T-Half 10 Mbps, half-duplex operation.

●

100TX-Full 100 Mbps, full-duplex operation.

●

100TX-Half 100 Mbps, half-duplex operation.

●

100TX-AUTO Limit auto-negotiation to a maximum link speed of 100 Mbps.

●

1000T FULL 1000 Mbps, full-duplex operation.

Locally Administered

Address

(Supported print servers only) Warning: Changing the locally administered address results

in the loss of connectivity to the browser.

Specify a locally administered address (LAA) to replace the factory assigned LAN

Hardware (MAC) address. If used, enter a string of exactly 12 hexadecimal digits.

For Ethernet print servers, the LAA address must start with hexadecimal X2, X6, XA, or XE,

where X is any hexadecimal digit 0 through F.

The default address is the factory assigned address.

Syslog Facility

Identify the source facility of a message. Typically used to identify the source of selected

messages during troubleshooting. By default, the HP Jetdirect print server uses LPR as the

source facility code. However, you can use values of local0 through local7 to isolate

individual or groups of print servers.

HTTP Idle Timeout

Length of time after which an idle HTTP connection is closed. Applies to the time after an

HTTP request or response completes. Enter from 5 to 60 seconds. The default is 15.

Set to zero (0) to disable. (The TCP/IP idle timeout value is used.)

86 Chapter 4 HP Embedded Web Server (V.40.xx)

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 205 206

Comentários a estes Manuais

Sem comentários

HP 690n Guia do Utilizador Página 96

Comentários a estes Manuais

Manuais e produtos relacionados com Redes HP 690n