HP 690n Guia do Utilizador descarregar pdf (Página 67)

Table 3-3 Telnet Commands and Parameters (continued)

appletalk

Use AppleTalk (EtherTalk) protocol operation on the print server.

0: Disable.

1 (default): Enable.

NOTE: On HP Jetdirect 635n print servers, all network protocols except TCP/IP are

disabled by factory default.

Name

(Read-only parameter.) Name of the printer on the AppleTalk network. A number after the

name indicates that this is the Nth instance of the name.

Print Type

(Read-only parameter.) AppleTalk network printer type reported by the HP Jetdirect print

server. Up to three print types can be reported.

Zone (Read-only parameter.) Name of the AppleTalk network zone on which the printer is

located.

Phase

(Read-only parameter.) AppleTalk phase 2 (P2) is pre-configured on the HP Jetdirect print

server.

Status

(Read-only parameter.) Current AppleTalk configuration status.

READY: HP Jetdirect print server is awaiting data.

DISABLED: AppleTalk was manually disabled.

INITIALIZING: Print server is registering the node address or name. An additional

status message might also be displayed.

DLC/LLC

dlc/llc-config

Use DLC/LLC protocol operation on the print server (if supported).

0: Disable.

1 (default): Enable.

NOTE: On HP Jetdirect 635n print servers, all network protocols except TCP/IP are

disabled by factory default.

strict-8022

Controls DLC/LLC protocol interpretation:

0 (default): Disable. Provide loose interpretation.

1: Enable. Provide strict interpretation.

Other

IPv4 configuration

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 205 206

Sem comentários

HP 690n Guia do Utilizador Página 67