HP 690n Guia do Utilizador descarregar pdf (Página 60)

Table 3-3 Telnet Commands and Parameters (continued)

write-mode

Set the TCP PSH flag for device-to-client data transfers.

0 (default): Disable.

1: Enable the all-push option, which sets the push bit in all data packets.

TCP/IP LPD Queues

addq Add a user-defined queue. Specify the queue name, prepend string name, append string

name, and the processing queue (typically, RAW) in the command line. Enter up to 32

alphanumeric characters. Add up to six user-defined queues.

CAUTION: Do not use lowercase and uppercase characters to differentiate queue

names. Management of LPD queues by other tools can cause unpredictable results.

deleteq

Set a user-defined deletion queue. Specify the queue name in the deleteq command

line.

defaultq

Set the queue name to use when the specified queue for a print job is unknown. The

default queue name is: AUTO

addstring

Specify a user-defined character string to prepend or append to print data. You can add

up to eight character strings. Specify the string name and the character string in the

addstring command line.

deletestring

Set a user-defined deletion string. Specify the string name in the deletestring

command line.

TCP/IP Raw Print Ports

raw-port

Additional ports for printing to TCP port 9100. Valid ports are application dependent and

range between 3000 to 9000. You can add up to two ports.

TCP/IP Access Control

allow Add an entry into the host access list stored on the HP Jetdirect print server. Each entry

specifies a host or network of hosts allowed to connect to the printer. The format is

allow netnum [mask] where netnum is a network number or host IP address, and

mask is an address mask of bits applied to the network number and host address to verify

access. Add up to 10 access list entries. If there are no entries, all hosts are permitted

access. The following are some example settings:

allow 192.0.0.0 255.0.0.0 Allows hosts on network 192.

allow 192.168.1.2 Allow a single host. The default mask 255.255.255.255 is

assumed and is not required.

allow 0 Clear the host access list.

For additional information, see

Security features (V.40.xx) on page 121.

TCP/IP Other

syslog-config Allow syslog server operation on the print server (UDP port 514).

0: Disable.

1 (default): Enable.

50 Chapter 3 TCP/IP configuration

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 205 206

Comentários a estes Manuais

Sem comentários

HP 690n Guia do Utilizador Página 60

Comentários a estes Manuais

Manuais e produtos relacionados com Redes HP 690n