HP 690n Guia do Utilizador descarregar pdf (Página 54)

Table 3-3 Telnet Commands and Parameters (continued)

Display current values.

Display the

Menu Interface on page 60 for use of the configuration parameters.

advanced

Enable advanced commands. Help (?) includes the advanced commands in the list.

general

Disable advanced commands. Help (?) does not include advanced commands (default).

save

Save the configuration values and exit the session.

exit

Exit the session.

export

Export the settings to a file for editing, and importing through Telnet or TFTP. (Only

available on systems that support input/output redirection, such as UNIX.)

General

passwd Password that allows administrators to control changes of HP Jetdirect print server

configuration parameters using Telnet, the HP Embedded Web Server, or HP Web

Jetadmin. For example, passwd jd1234 jd1234 sets the password to jd1234. (You

must enter the password jd1234 twice for confirmation.)

Enter up to 16 alphanumeric characters. Clear the password using a cold reset or enter

the command without a password and confirmation entry.

sys-location

Physical location of the device. Enter up to 255 alphanumeric characters.

sys-contact

Name of the network or device administrator. Enter up to 255 alphanumeric characters.

ssl-state

Print server's security level for Web communications, using the following values:

1: Enable forced redirection to the HTTPS port. Use only HTTPS (secure HTTP)

communications.

2: Disable forced redirection to HTTPS. Use both HTTP and HTTPS communications.

security-reset Reset security settings on the print server to factory default values.

0 (default): Do not reset.

1: Reset.

Wireless 802.11 Main

network-type 802.11g wireless network topology:

Infrastructure: The print server communicates on the network with other wired or

wireless devices through an access point.

Ad Hoc: (default) The print server communicates with other wireless devices directly,

without using an access point.

desired-ssid Service set identifier (SSID), or network name, for the print server. Enter up to 32

alphanumeric characters.

The factory-default SSID is hpsetup in ad hoc mode. Do not use the SSID hpsetup with

the Infrastructure network type.

If the ssid command is issued without an entry (a blank SSID), the desired SSID is

assigned <AUTO>, where it associates with the first network that matches its

authentication settings.

44 Chapter 3 TCP/IP configuration

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 205 206

Comentários a estes Manuais

Sem comentários

HP 690n Guia do Utilizador Página 54

Comentários a estes Manuais

Manuais e produtos relacionados com Redes HP 690n