HP 690n Guia do Utilizador Página 69

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 68
Table 3-3 Telnet Commands and Parameters (continued)
network-select
(For HP Jetdirect products with a dual wired/wireless port. Specifies the active behavior of
the print server.)
Auto (default): Automatically detects whether a network cable is attached. If a
network cable is not attached, only the IEEE 802.11g wireless port is active. If a
network cable is attached, then only the IEEE 802.3 wired port is active.
CAUTION: Do not plug a network cable into an active wired/wireless port if the
network-select command is set to Auto. Wireless access will immediately terminate.
Wired: Only the 802.3 wired port is active.
Wireless: Only the 802.11g wireless port is active.
link-type (For wired 10/100/1000T Ethernet.) Set the print server's link speed (10, 100, 1000
Mbps) and communication mode (Full- or Half-Duplex). The available link-speed depends
on the print server model. Select from the following communication modes:
AUTO (default): Use auto-negotiation to configure the highest link speed and
communication mode allowed.
1000FULL: 1000 Mbps, full-duplex operation.
100AUTO: Limit auto-negotiation to a maximum link speed of 100 Mbps.
100FULL: 100 Mbps, full-duplex operation.
100HALF: 100 Mbps, half-duplex operation.
10FULL: 10 Mbps, Full-duplex operation.
10HALF: 10 Mbps, half-duplex operation.
usb-mode Communication mode over the USB port on the HP Jetdirect print server.
Auto (default): Automatically negotiate and set the highest communication mode
possible for the attached printer or device.
MLC: HP proprietary (multiple logical channels) mode that allows multiple channels of
simultaneous print, scan, and status communication.
BIDIR: Standard connection that supports bi-directional communication between the
printer and print server.
UNIDIR: Standard connection in which data is transferred in one direction only (to
the printer).
usb-speed (Read-only parameter, USB 2.0 products only.) Auto-negotiated communication speed
over the USB connection between the HP Jetdirect print server and the device.
Full Speed: 12 Mbits/sec as specified in the USB v2.0 specifications, compatible
with USB v1.1 specifications.
Hi-Speed: 480 Mbits/sec for USB v2.0 devices only.
Disconnected: USB port is not connected.
hw-acclrn-conf
Use hardware acceleration.
0: Disable.
1 (default): Enable.
IPv4 configuration
59
Vista de página 68
1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 205 206

Comentários a estes Manuais

Sem comentários