HP 690n Guia do Utilizador descarregar pdf (Página 83)

Table 4-3 Wireless configuration parameters (continued)

Item Description

WPA — Personal

Choose WPA– Personal, which uses a pre-shared key typically generated by a

passphrase.

Enter the Passphrase to use when generating the pre-shared key for WPA — Personal

authentication on your network. A passphrase must be from 8 to 63 ASCII characters in

the hexadecimal range 21 through 7E (characters 0–9, a–z, A–Z and numerous special

characters including !, @, #, $, %, ^, &, (, ), _, +, =, −, {, }, [, ], \, /, “, <, >, ?, “, ‘, ˜).

WPA — Enterprise

Select WPA — Enterprise security if your network uses WPA with EAP/802.1x

authentication. This type of security utilizes a central authentication server, such as

RADIUS, to authenticate users on the network. For WPA — Enterprise, the HP Jetdirect

print server supports these server-based authentication protocols: LEAP PEAP EAP-TLS.

Provide the following if you select WPA — Enterprise:

●

Enabled Protocols: Select LEAP, PEAP, or EAP-TLS. LEAP (Lightweight Extensible

Authentication Protocol) is a proprietary protocol from Cisco Systems that uses

passwords for mutual authentication (the client and the server authenticate each

other). PEAP (Protected Extensible Authentication Protocol) is a mutual authentication

protocol that uses digital certificates for server authentication and passwords for

client authentication. For additional security, the authentication exchanges are

encapsulated within TLS (Transport Level Security). EAP-TLS (EAP using Transport

Level Security) is a mutual authentication protocol based on digital certificates.

●

User Name: Enter an EAP/802.1X user name, which cannot exceed 128

characters, for this device. The default user name is the default host name of the print

server, NPIxxxxxx, where xxxxxx are the last six digits of the LAN hardware (MAC)

address.

●

Password and Confirm Password: Enter an EAP/802.1X user password (up to

128 characters) for this device and then confirm the password by entering it again.

●

Server ID: Specify the Server ID validation string identifying and validating the

authentication server. This string is specified on the digital certificate issued by a

trusted Certificate Authority (CA) for the authentication server. The entry can be a

partial string unless you select Require Exact Match.

●

Encryption Strength: Specify the minimum encryption strength to use during

communications with the authentication server. You can select Low, Medium, or High

encryption strength. For each encryption strength, ciphers are specified to identify

the weakest cipher allowed.

●

Jetdirect Certificate: A self-signed HP Jetdirect certificate is preinstalled and used

to validate the identity of the HP Jetdirect device to clients and to network

authentication servers. This allows the HP Embedded Web Server to use HTTPS and

appear as a secure site when accessed by a Web browser. Click Configure to

update the certificate or install a new one.

●

CA Certificate: To validate the authentication server's identity, a CA (or Root)

certificate must be installed on the print server. This CA certificate must be issued by

the Certificate Authority who signed the authentication server's certificate. Click

Configure to configure or install a CA certificate.

Restore Defaults

Click this button to restore 802.1X configuration settings to factory default values.

Networking tab

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 205 206

Comentários a estes Manuais

Sem comentários

HP 690n Guia do Utilizador Página 83

Comentários a estes Manuais

Manuais e produtos relacionados com Redes HP 690n