HP 690n Guia do Utilizador descarregar pdf (Página 57)

Table 3-3 Telnet Commands and Parameters (continued)

Current Channel (Read-only parameter) The channel that the wireless print server is currently using.

Signal Strength (Read-only parameter) Strength of the radio signal received by the print server.

<blank>: No radio signal detected while the print server is scanning.

No Signal: No radio signal detected on any channel.

Poor/Marginal/Good/Excellent: Detected signal strength level.

Access Point Mac (Read-only parameter) The media access control (MAC) address of the access point used

for Infrastructure mode communications, as in the following example:

00:a0:f8:38:7a:f7

In this example, the access point with MAC address 00a0f8387af7 is used for

communicating on the network.

TCP/IP Main

llmnr

Link local multicast name resolution (LLMNR).

0: Disable.

1 (defualt): Enable.

host-name Name of the network device. Enter up to 32 alphanumeric characters.

For example, host-name printer1 assigns the name printer1 to the device. The

default host name is NPIxxxxxx, where xxxxxx are the last six digits of the LAN hardware

(MAC) address.

ip-config Print server configuration method. Use the following values:

manual: Wait for IP parameters using manual tools, such as Telnet, the HP Embedded

Web Server, the control panel, or installation/management software. Status is User

Specified.

bootp: Send BOOTP requests on the network for dynamic IP configuration.

dhcp: Send DHCP requests on the network for dynamic IP configuration.

auto_ip: Automatically configure with a unique link-local address 169.254.x.x.

ipsec-config

firewall-config

NOTE: The ipsec-config command is available on print servers that support both

IPsec and Firewall configuration. The firewall-config command is available on full-

featured print servers that do not support IPsec, but allow Firewall configuration.

Disable IPsec or Firewall operation on the print server after IPsec/Firewall policies are

configured and enabled. You cannot enable IPsec/Firewall operation using this

command. Instead, use the HP Embedded Web Server to configure and enable IPsec/

Firewall polices.

0: Disable IPsec/Firewall operation.

1: (Read Only) IPsec/Firewall policies are configured and enabled.

IPv4 configuration

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 205 206

Sem comentários

HP 690n Guia do Utilizador Página 57