HP 690n Guia do Utilizador descarregar pdf (Página 68)

Table 3-3 Telnet Commands and Parameters (continued)

upgrade

Set the name and location of the firmware upgrade file for the HP Jetdirect print servers.

CAUTION: Ensure that command parameters are properly entered and that the

upgrade file is a higher version than the currently installed version. The print server

attempts to upgrade if the upgrade file contains a higher version than the installed

version.

The following is the command format:

upgrade: <TFTP server IP> <Version> <Product Number> <Filename>

The following defines the parameters:

<TFTP Server IP> IP address of the TFTP server, <Version> firmware version of the

upgrade file, <Product Number> print server product number <Filename> path and

filename of the firmware upgrade file.

laa Specify a locally administered address (LAA) to replace the factory-assigned LAN

hardware (MAC) address. If LAA is used, enter a string of exactly 12 hexadecimal digits.

For Ethernet print servers, the LAA must start with hexadecimal X2, X6, XA, or XE, where X

is any hexadecimal digit 0 through F.

The default address is the factory-assigned address.

xml-services-conf

Allow access by HP Web service applications to XML-based data on the HP Jetdirect print

server.

0: Disable.

1 (default): Enable.

ws-discovery-conf

Allow Microsoft WS discovery protocols on the print server.

1 (default): Enable.

0: Disable.

1000t-ms-conf

Configure the print server as a master or slave device on a 1000T network.

AUTO or 0 (default): Master/slave configuration is automatically sensed and assigned.

MASTER or 1: Configure as a 1000T master device.

SLAVE or 2: Configure as a 1000T slave device.

1000t-pause-conf Control the flow of inbound and outbound data.

OFF or 0 (default): Disable flow control.

AUTO or 1: Configure through auto-negotiation with the network switch.

RCV or 2: Enable only for data received from the network.

TRANS or 3: Enable only for data transmitted to the network.

TXRX or 4: Enable for both received and transmitted data.

58 Chapter 3 TCP/IP configuration

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 205 206

Sem comentários

HP 690n Guia do Utilizador Página 68