
Table C-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item Sub-menu item Sub-menu item Values and Description
Diagnostics Embedded Tests (HP Jetdirect embedded print servers only.) Diagnose
network hardware or TCP/IP network connection
problems.
Use an embedded test to check hardware and
communication paths on the print server. After you
select and enable a test and set the execution time,
select Execute to initiate the test.
Depending on the execution time, a selected test runs
continuously until either the device is turned off, or an
error occurs and a diagnostic page is printed.
LAN HW Test
CAUTION: Running this embedded test erases your
TCP/IP configuration.
Performs an internal loopback test, which sends and
receives packets only on the internal network
hardware. There are no external transmissions.
Yes: Select this test.
No: Do not select this test.
HTTP Test Check operation of HTTP by retrieving predefined
pages from the device, and test the HP Embedded
Web Server.
Yes: Select this test.
No: Do not select this test.
SNMP Test Checks operation of SNMP communications by
accessing predefined SNMP objects on the device.
Yes: Select this test.
No: Do not select this test.
Data Path Test Identify data path and corruption problems on an HP
postscript level 3 emulation device. Sends a
predefined PS file to the device. However, the file
does not print (paperless).
Yes: Select this test.
No: Do not select this test.
Select All Tests Run all the embedded tests.
Yes: Run all tests.
No: Do not run all tests.
Execution Time [H] Specify the length of time (in hours) that an embedded
test runs, using a value from 1 to 60. If you select zero
(0), the test runs indefinitely until an error occurs or the
device is turned off.
Data gathered from the HTTP, SNMP, and Data Path
tests is printed after the tests complete.
182 Appendix C HP Jetdirect control panel menus (V.40.xx)
Comentários a estes Manuais