HP 690n Guia do Utilizador descarregar pdf (Página 151)

Table 8-4 802.11 Wireless settings (continued)

Message Description

Signal Strength (1–5) Strength of the radio signal received by the print server:

Level 1(Poor)

Levels 2 and 3 (Marginal)

Level 4 (Good)

Level 5 (Excellent)

No Signal: Level 0 (No radio signal detected on any channel)

<blank>: No radio signal detected while the print server is scanning.

Not Applicable: Signal strength is not applicable when the print server is in ad hoc

mode.

Network Connection Type Specifies the type of network connection: Wireless or Wired.

Access Point / BSSID Basic service set identifier (BSSID) is a 6-byte number that distinguishes one wireless

LAN (WLAN) from another, even if they have the same network name (SSID).

Infrastructure Mode: The MAC address or name of the access point to which the

HP Jetdirect wireless print server is connected.

Ad Hoc Mode: A random number or name generated by the initiator of the ad hoc

network.

Channel Radio frequency channel that the print server sensed and configured for communication

on the network. Because it was automatically sensed from the network, this channel

can be different than the user-configured channel, which is only used for broadcasts if

the specified network/SSID is not found.

Channel number values 1 through14 might display. The allowed channels are country/

region-dependent.

Authentication Type Level of encryption configured on the HP Jetdirect print server.

No Security (Open System): Positive validation of a device's identification is not

required for network access unless the network requires EAP authentication. An

authentication failure can indicate that an EAP authentication server has rejected

network access.

WEP: Each device on the network is configured with a shared secret WEP key which is

required to gain access to the network. Authentication failures for the HP Jetdirect print

server can arise if the installed key is faulty, or the wrong key is active, when multiple

keys are configured and stored on the print server.

WPA: For enhanced security, Wi-Fi protected access using a pre-shared key is

configured. The pre-shared key is generated by the print server through a user-specified

network passphrase configured on the print server.

User Name User identity.

CA Server ID ID of the CA server.

SSL Certificate Indicates whether the SSL certificate is Installed or Not Installed.

SSL Version Version of the installed SSL protocol.

SSL Issuer Entity issuing the CA certificate.

HP Jetdirect configuration page

141

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 205 206

Comentários a estes Manuais

Sem comentários

HP 690n Guia do Utilizador Página 151

Comentários a estes Manuais

Manuais e produtos relacionados com Redes HP 690n