HP 690n Guia do Utilizador descarregar pdf (Página 65)

Table 3-3 Telnet Commands and Parameters (continued)

snmp-config SNMP operation on the print server.

CAUTION: Disabling SNMP disables all SNMP agents (SNMP v1, v2, v3) and

communications with management applications, such as HP Web Jetadmin. In addition,

firmware upgrades through current HP downloading utilities is disabled.

0: Disable.

1 (default) Enable.

get-cmnty-name Optional. Password to determine which SNMP GetRequests the HP Jetdirect print server

responds to. If a Get community name is set, the print server responds to either a user-

specified community name or the factory-default. Enter up to 255 alphanumeric

characters.

set-cmnty-name

Password to determine which SNMP SetRequests (control functions) the HP Jetdirect print

server responds to. The community name of an incoming SNMP SetRequest must match

the print server's set community name for the print server to respond. (For additional

security, you can limit configuration access through the print server's host access list.)

Enter up to 255 alphanumeric characters.

default-get-cmnty

Default Get community name.

0 Disable.

1 (default): Enable.

Disabling this parameter can prohibit communications with SNMP management

applications.

SNMP Traps

auth-trap

Send SNMP authentication traps. Authentication traps indicate that an SNMP request was

received, but the community name check failed.

0 Disable.

1 (default) Enable.

trap-dest Add a host's IP address to the HP Jetdirect print server's SNMP trap destination list. The

list can contain up to six entries. To receive SNMP traps, the listed systems must have a

trap daemon that listens for the traps. The following is the command format:

trap-dest: <ip-address> [community name] [port number]

In the example, <ip-address> is the IP address of the host to receive traps,

[community name] specifies the SNMP community name, and [port number]

identifies the port number to use.

The default community name is public. The default SNMP port number is 162. You must

enter a community name to specify a port number.

To delete the list, set trap destination to zero (trap-dest: 0).

By default, the SNMP trap destination list is empty and the print server does not send

SNMP traps.

IPX/SPX

IPv4 configuration

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 205 206

Comentários a estes Manuais

Sem comentários

HP 690n Guia do Utilizador Página 65

Comentários a estes Manuais

Manuais e produtos relacionados com Redes HP 690n