HP 690n Guia do Utilizador descarregar pdf (Página 53)

By default, the Telnet interface does not require a user name or password. If an administrator

password is set, enter the user name and password. Otherwise, you cannot enter or save Telnet

settings.

By default, a command line interface is provided. To set parameters using a menu interface, enter

Menu. For more information, see

Telnet user interface options on page 43.

For a list of supported commands and parameters, see

Table 3-3 Telnet Commands and Parameters

on page 43.

Telnet user interface options

The HP Jetdirect print server provides two interface options to enter Telnet commands: a Telnet

command line interface (default) on page 43 and a Menu Interface on page 60.

Telnet command line interface (default)

Using the Telnet command line interface, you can set configuration parameters using the following

procedures:

NOTE: To view supported commands, formats, and parameters, type ?.

To list additional (or advanced) commands, type advanced before entering ?.

To display current configuration information, type /.

At the > Telnet prompt, type the following and press Enter:

The <command parameter> signifies the configuration parameter, and <value> is the value

assigned to that parameter. Follow each command entry with Enter (carriage return).

See

Table 3-3 Telnet Commands and Parameters on page 43 for configuration parameters.

Repeat the previous step to set any additional configuration parameters.

When you have finished setting the configuration parameters, type exit or quit (depending on

your system).

Indicate whether to save any changes by entering Y (default) for Yes, or N for No.

If you enter save instead of exit or quit, you are not prompted to save settings.

Telnet commands and parameters.

Table 3-3 Telnet Commands and Parameters on page 43

lists the available Telnet commands and parameters.

NOTE: If a parameter is dynamically provided by a BOOTP or DHCP server, you cannot change its

value unless you set Manual configuration. See the ip-config command.

When you manually set an IP address, you should also re-set the subnet mask and default gateway.

Table 3-3 Telnet Commands and Parameters

Command Description

User Control Commands

Display the Help and Telnet commands.

IPv4 configuration

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 205 206

Sem comentários

HP 690n Guia do Utilizador Página 53