
Chapter 6 - Servicing the Array
110
VMA-series Memory Array Installation and Service Guide
HP-AM456-9002A Rev 01
Where:
3. At the context prompt, type:
The command displays information similar to the following:.
Testing the VIMM LEDs
Test the LEDs associated with a specific VIMM. The slot ID is specified when you
navigate to the Slot context level. The LEDs stay lit for two seconds, blink fast for
two seconds, blink slowly for two seconds, then return to the previous state.
To test the VIMM LEDs:
1. Log into the Memory Array.
2. Navigate to the
Slot
context level. At the root prompt, type:
Where:
3. At the context prompt, type:
n Specifies the VIMM slot ID. Valid values are in the range of 0-
83, inclusive.
show led-state
chassis board 0 slot 12> show led-state
led-state slow-flash
context chassis board 0 slot <n>
n Specifies the VIMM slot ID. Valid values are in the range of 0-83.
set led-test start
Comentários a estes Manuais