HP VMA-series Memory Arrays Manual do Utilizador descarregar pdf (Página 49)

Connecting Power

HP-AM456-9002A Rev 01

VMA-series Memory Array Installation and Service Guide

2. Route the equipment ground cable to the rear of the equipment. Be sure to

leave an appropriate service loop to allow the removal of the equipment on

the slide rails. If using the cable management arm, route the equipment

ground wire around the arm. See Routing the Cables onto the Cable

Management Arm on page 55.

3. Cut the length of the ground wire at the rear of the equipment as needed

for proper fit. If the length of the cable is cut, strip 13 mm (½ in) of

insulation from the cut end of the cable for installation into the grounding

lug.

4. Attach the ground cable to the loose grounding lug provided with the

Memory Array. Tighten the screw on the lug to secure the cable to the lug.

5. Using the grounding screw provided with the Memory Array, attach the lug

to the ground point on the rear of the equipment.

Note: Attach the lug with the cable pointing up. Attaching the lug with the

cable pointing down may cause interference between the ground cable and

equipment mounted directly below the Memory Array which would prevent

the Memory Array from sliding out of the equipment rack for serviceability.

If ground cable not included in accessory kit

When installing a grounding cable, be sure to allow a sufficient service loop to

allow the array to be removed from the front of the rack for serviceability.

One end of the grounding cable should be attached to an appropriate ground

location on the equipment rack. The other end of the ground cable should be

attached to the grounding location on the rear of the Memory Array using a

¼-20 x ½" (max length) size screw.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 299 300

Sem comentários

HP VMA-series Memory Arrays Manual do Utilizador Página 49