HP VMA-series Memory Arrays Manual do Utilizador descarregar pdf (Página 46)

Chapter 3 - Installing the Array

VMA-series Memory Array Installation and Service Guide

HP-AM456-9002A Rev 01

Connecting the PCIe Cable to the Memory Array

The Memory Array communicates with the host computer via the PCIe

(Peripheral Component Interconnect Express) connection. The PCIe cable must

be connected to the PCIe port with the flashing LED. The software image on the

system dictates which interface port is used. The image names are listed in the

table below.

Where <release> indicates the release number; for example, A3.7.2-18919.

Note: Ensure that the:

• Bend radius of the PCIe cable is greater than 1.9".

• PCIe cable is connected to the port with the flashing LED.

To connect the PCIe cable to the Memory Array PCIe connector:

1. Locate the appropriate PCIe connector port at the rear of the Memory

Array. This is indicated by the flashing LED that is associated with the port.

Figure 3.5 Connecting the PCIe Cable to the Memory Array

Orient one connector of the PCIe cable so it aligns appropriately with the

PCIe connector at the rear of the Memory Array.

3. Securely plug the cable into the PCIe connector port on the Memory Array.

4. If using the cable management arm, route the PCIe cable according to the

instructions in Routing the Cables onto the Cable Management Arm on

page 55.

Table 3.2 Image Names

Image Name PCIe Interface Interface ID

v3000_Series_x8_p1_df-<release>.upg PCIe x8 Interface for V3000 Port 1

v3000_Series_x4_p1p2_df-<release>.upg Dual PCIe x4 Interfaces for V3000 Ports 1 and 2

LOC

A RAID

ADMIN

AC OK

DC OK

STATUS

ALARM

PCIe

Port 1

PCIe

Port 2

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 299 300

Sem comentários

HP VMA-series Memory Arrays Manual do Utilizador Página 46