HP VMA-series Memory Arrays Manual do Utilizador descarregar pdf (Página 51)

Connecting Management Network

HP-AM456-9002A Rev 01

VMA-series Memory Array Installation and Service Guide

Figure 3.7 Connecting the Serial Cable to the Memory Array

If using the cable management arm, route the serial cable according to the

instructions in Routing the Cables onto the Cable Management Arm on

page 55.

3. At the rear of the host computer, plug the other end of the serial cable into

the male DB-9 connector, see Figure 3.8. Secure the connection by

tightening the screws on the DB-9 connector.

Figure 3.8 Connecting the Serial Cable to the Host Computer

Connecting the Ethernet Cable

The Ethernet cable connects the host computer to the system’s command line

interface (CLI) for configuration operations and retrieving system status.

For a direct host-to-system Ethernet connection, use a straight-through or cross-

over RJ-45 to RJ-45 CAT5 Ethernet cable. You can also use a straight-through

or cross-over cable to connect the Memory Array to a router, hub, or other

network device, provided that the host and the system can communicate with

each other.

To connect the Ethernet cable to the Memory Array and the host computer:

1. Connect one RJ-45 connector on the Ethernet cable to the RJ-45

connector labeled ETHERNET on the rear of the Memory Array, as shown in

the figure below.

LOC

A RAID

ADMIN

AC OK

DC OK

STATU S

ALARM

Serial

Console

Serial

Console

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 299 300

Sem comentários

HP VMA-series Memory Arrays Manual do Utilizador Página 51