HP VMA-series Memory Arrays Manual do Utilizador descarregar pdf (Página 43)

Rack-Mounting the Chassis

HP-AM456-9002A Rev 01

VMA-series Memory Array Installation and Service Guide

Figure 3.2 Installing the Memory Array into a Rack

To install the Memory Array into a 19" equipment rack:

1. Remove the Memory Array from the shipping packaging and remove all

packing materials. Visually inspect the system for any shipping damage and,

if any damage is detected, contact HP Customer Support for replacement

parts.

2. Install the toolless mounting rails at the appropriate height in your

equipment rack. Orient the rails so they slide out to the front of the rack.

3. Fully extend the rails until they lock into place. Position the Memory Array

above the rails and slide the buttons at the rear sides of the chassis into the

rear slots on the rails.

4. Slip the remaining sets of buttons into the remaining cutouts in the rails.

Push the whole assembly back into the equipment rack and secure the rack

mounting brackets to the front of the equipment rack with the thumb

screws located on the front mounting brackets, as shown in Figure 3.2.

Installing the Cable Management Arm

Install the optional cable management arm at the rear of the chassis. The arm

consists of a mounting bracket and cable holder and keeps the cables from

becoming entangled when the system is fully extended from the equipment rack.

The cables are routed along the length of the arm and held in place with cable

ties. The cable management arm is not installed prior to shipping.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 299 300

Sem comentários

HP VMA-series Memory Arrays Manual do Utilizador Página 43