HP VMA-series Memory Arrays Manual do Utilizador descarregar pdf (Página 70)

Chapter 4 - Configuring the Array

VMA-series Memory Array Installation and Service Guide

HP-AM456-9002A Rev 01

Verifying the Ethernet Connection

The Ethernet interface can also be used to connect to the CLI of the Memory

Array. This section explains how to verify that the Ethernet connection is

operating properly.

To verify the Ethernet connection:

1. Log in to the host computer, as root on a Linux host or as an

administrator on a Windows host.

2. To retrieve the IP address of the Memory Array, do one of the following:

a. Log into the CLI via the serial port connection (see Logging into the CLI

via the Serial Interface on page 59) and type the following command at

the command prompt:

This command returns the system’s IP address and other Ethernet

settings.

b. Connect to your DHCP server and retrieve the IP address it assigned to

your Memory Array.

3. Open a terminal or command line window and, at the command prompt,

type:

Where:

If the host computer can connect to the Memory Array, then it will return a

successful ping message. If it cannot connect, then a failed ping message is

returned.

You can also connect to the system via the Ethernet port using Telnet or SSH as

described in Connecting to the CLI on page 76. If you are using DHCP and DNS,

you can use the system’s name instead of the IP address to connect through the

network.

show chassis controller ethernet 0

$ ping {<memory-array_ip_address> | <memory-array_name>}

memory-array_ip_address The IP address assigned to the

Memory Array.

memory-array_name The name of the Memory Array if

using DHCP and the memory array

is registered in the DNS.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 299 300

Sem comentários

HP VMA-series Memory Arrays Manual do Utilizador Página 70