HP VMA-series Memory Arrays Manual do Utilizador descarregar pdf (Página 295)

Sw-upgrade Context Commands

HP-AM456-9002A Rev 01

VMA-series Memory Array Installation and Service Guide

295

set active

Sets the specified partition in flash to be activated during the next reboot of the

Memory Array.

Syntax

set active {upgrade | factory}

Where:

set path

Sets the path where the upgrade software is located. After the command is run,

the upgrade software is downloaded to RAM on the main board and then copied

into the upgrade partition of flash.

Syntax

set path <path>

Where:

show active

Displays the specified partition in flash to be activated during the next reboot of

the Memory Array. Use this command after the set active command during

an upgrade procedure.

Syntax

show active

upgrade Sets the upgrade partition in flash to be activated

during the next system reboot. The upgrade partition

contains the downloaded upgrade software.

factory Sets the factory partition in flash to be activated upon

the next system reboot. The factory partition contains

the factory configuration defaults.

path

Sets the path where the upgrade software is located. A

valid path format is user@ftp://host/path/

upgrade.img.

1 2 ... 290 291 292 293 294 295 296 297 298 299 300

Sem comentários

HP VMA-series Memory Arrays Manual do Utilizador Página 295