HP VMA-series Memory Arrays Manual do Utilizador descarregar pdf (Página 287)

Syslog Context Commands

HP-AM456-9002A Rev 01

VMA-series Memory Array Installation and Service Guide

287

Syslog Context Commands

Figure D.22 System>Logging>Syslog Context Level

The table below describes the commands available at the Syslog context sublevel

of the CLI. Access the Syslog context sublevel through the Logging context level.

See Logging Context Commands on page 279.

set host

Sets the IP address of the host that will receive the system log. This host must

have syslogd configured correctly. The Memory Array sends messages to only

one syslog server at a time. See your host’s syslogd documentation for

instructions. Display the man page for syslog.conf on your host for more

information.

Syntax

set host <ip_address>

Table D.25 Syslog Context Commands

Command Description

set host Sets the IP address for the syslogd host.

set service Enables or disables the service that sends the system

log.

show host Displays the IP address for the syslogd host.

show service Displays if the service that sends the system log to a

host is enabled or not.

1 2 ... 282 283 284 285 286 287 288 289 290 291 292 ... 299 300

Sem comentários

HP VMA-series Memory Arrays Manual do Utilizador Página 287