HP VMA-series Memory Arrays Manual do Utilizador descarregar pdf (Página 130)

Chapter 7 - Linux Drivers

130

VMA-series Memory Array Installation and Service Guide

HP-AM456-9002A Rev 01

3. At the Command prompt, type n to create a new partition:

Where

n specifies to create a new partition.

The command displays information similar to the following:

4. Next, at the Command prompt, create the new partition by typing:

Where

p creates a primary partition.

The command displays information similar to the following:

• Specify the partition number if you will be creating more than one

partition on the device, or accept the default value of

1 by pressing the

Enter key. The default value to set the beginning cylinder to is

1, which

can be changed if needed.

• Specify the size of the block device or accept the default value of the

available memory by pressing the Enter key.

5. Next, at the Command prompt, write the new partition by typing:

Where

w writes the partition table to disk and exit.

Command (m for help): n

Command action

e extended

p primary partition (1-4)

Command action

e extended

p primary partition (1-4)

Partition number (1-4): 1

First cylinder (1-16709, default 1):

Using default value 1

Last cylinder or +size or +sizeM or +sizeK (1-16709, default

16709): 8000

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 299 300

Sem comentários

HP VMA-series Memory Arrays Manual do Utilizador Página 130