HP VMA-series Memory Arrays Manual do Utilizador descarregar pdf (Página 72)

Chapter 4 - Configuring the Array

VMA-series Memory Array Installation and Service Guide

HP-AM456-9002A Rev 01

Setting the IP Address for the Syslog Host

Send system log messages to a host attached to the Memory Array via the

Ethernet port. This host must have syslog configured correctly. See your host’s

syslog documentation for instructions.

Note: From the CLI prompt, use the ping command to verify the connection

between the Memory Array and the remote syslog host.

To set the IP address of the host to which the system log messages will be sent:

1. Log into the Memory Array.

2. Navigate to the

Syslog

context level. At the root prompt, type:

3. At the

Syslog

context prompt, type:

Where:

4. To commit the change made to the IP address, from the

System

context

level command prompt, type:

Or, from the

Syslog

context level, type:

Determining the Status of the System Log

Service

Display the status of the service that sends the system log messages to a host.

1. Log into the Memory Array.

2. Navigate to the

Syslog

context level. At the root prompt, type:

3. At the

Syslog

context prompt, type:

context system logging syslog

set host <ip_address>

ip_address Specifies the IP address of the syslog host to which

the system log messages will be sent.

save config

top

save config

save system config

context system logging syslog

show service

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 299 300

Comentários a estes Manuais

Sem comentários

HP VMA-series Memory Arrays Manual do Utilizador Página 72

Comentários a estes Manuais

Manuais e produtos relacionados com Servidores HP VMA-series Memory Arrays