HP B160L Manual do Utilizador Página 207

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 367
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 206
HP Visualize C132L & C160L Internals
Buses
GSC-2 system and I/O bus (33MHz with 132MB/s peak data rate on C132L, 40MHz 160MB/s
on C160L)
EISA additional expansion I/O bus
PCI-32/33 high-performance device I/O bus
SCSI-2 single-ended bus
SCSI-2 Fast-Wide differential main storage I/O bus
Memory
72-pin ECC SIMMs, 60ns or faster
Bus width: 128 data bits with 16 check bits
Up to 8-way interleaving
Takes 16-256MB modules
12 slots
32MB (2×16) minimum, 2GB maximum
Expansion
Two slots for either GSC (EISA formfactor) or EISA cards
One slot for either a PCI 32-bit/33MHz, 3V or EISA card
One slot for a PCI 32-bit/33MHz, 3V card
Slot layout (from top to bottom):
1. EISA or GSC
2. EISA or GSC
3. PCI-32/33 3V or EISA
4. PCI-32/33
Drives
The disk-slider can accomodate up to three SCSI drives and one floppy drive simultaneously, the internal
cabling (usually) includes one Wide-SCSI cable with three 68-pin connectors and a HVD-terminator at
the end, one Narrow-SCSI with one 50-pin connector and one cable for the floppy.
The Narrow-SCSI cable is normally used for the external-accessible half-height 5.25 CD/DAT drive,
although it is of course also possible to connect a 50-pin SE hard drive. The cable can also be easily
replaced with a variant with more connectors to use up to three 50-pin SE hard drives. The PDC can
boot off these SE drives.
200
Vista de página 206
1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 366 367

Comentários a estes Manuais

Sem comentários