HP Vectra 520 Guia de Instalação descarregar pdf (Página 121)

4-14 Hardware installation: Intelligent Peripheral Equipment module

553-4001-111 Standard 1.0 March 1997

Meridian MAX IPE/IPE-E module—Option 11

If you have obtained a new Meridian MAX IPE/IPE-E system, the module

is already assembled. It is necessary for you to insert the module into the

Option 11.

When you remove the front panel of the main cabinet of the Option 11 or

the front panel of an expansion cabinet, there are a number of slots,

numbered 2 to 9 in the main cabinet and 11 to 20 in the expansion cabinet,

where the Meridian MAX IPE/IPE-E module can be inserted. Slots 10–12

in the main cabinet are reserved for Meridian Mail and cannot be used for

Meridian MAX IPE/IPE-E. The Meridian MAX IPE/IPE-E module

occupies any three consecutive slots. Its slot placement is determined by the

slot positions of existing applications already installed in either of the

Option 11 cabinets. The slot placements of future applications for your

system are also a consideration when deciding the slot placement for your

Meridian MAX IPE/IPE-E.

When the slot placement has been determined, slowly slide the module

along the slots into the cabinet, making sure the latches at the top and

bottom of the module are in an unlatched position, until it is firmly in place.

Make sure the latches at the top and bottom of the module are secured.

Input/output cables

Main cabinet

Two shielded four

-port cables are used to connect the Meridian MAX

IPE/IPE-E to its supervisor workstation, printers, and other peripheral

devices. Cable A (NT1R03AA) has a 50-pin key telephone connector on

one end and four DB-25 female connectors on the other, as well as an

additional Ethernet port, shown in Figure 4-14. Cable B (NT1R03BA) is

identical to Cable A except that it has no additional Ethernet port, shown in

Figure 4-14. Each of the eight female DB-25 connectors can connect to a

peripheral device. Cable A services Ports 1, 3, 5, and 7. Cable B services

Ports 2, 4, 6, and 8. Refer to the Communication Port Assignment Sheet

(Table 4-4) when connecting peripherals to cables.

Underneath the main cabinet of the Option 11 is a connector panel with 10

numbered connector ports. Each connector port connects to the

corresponding numbered slot directly above, inside the main cabinet. The

key telephone connectors of each four-port cable are connected here. These

connectors are held in place by a removable connector panel bar.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 502 503

Sem comentários

HP Vectra 520 Guia de Instalação Página 121