HP Vectra 520 Guia de Instalação descarregar pdf (Página 55)

100

101

Site preparation 2-21

Meridian MAX

Installation Guide

Product release 8

CDP dialling plan and UDP just for NACD routing tables

There are cases in which it is preferable to use a CDP dialing plan other

than seven digits. When this is the case, CDP can be used for non-NACD

environments, and UDP can be configured for just the NACD application.

Define AC1 or AC2 in Overlay 86, ESN Data Block.

Define the Location Codes (LOC) and Home Location Code in Overlay 90,

Network Translation Data Block. The HLOC should have a DMI that

deletes 3.

In Overlay 15, Customer Data Block, define HLOC as the already-defined

HLOC in Overlay 90.

If AC2 is used within the NACD tables, then put LOC after AC2.

If AC1 is used within the NACD tables, then do not put LOC after AC2.

Either AC1 or AC2, but not both, can be used in the NACD tables per

NACD node. That means that node A can use AC1 in its NACD Routing

Table, and node B can use AC2 in its NACD Routing Table, but node A

cannot use AC1 and AC2 within its NACD Routing Table.

In Overlay 16, Route Data Block, define INAC as YES on all incoming

ISDN routes in the network. This programming must be done at all nodes

in the network.

The three-digit node identification is equivalent to the HLOC or LOC, or

the Network ACD node, and is also required to be programmed in the

Meridian MAX system. This programming is done in the Network

Definition/Installation screen under Maintenance and Administration

Programs.

Note: When assigning Route List Index (RLI) entries in Overlay 87 or

Overlay 90 for DSCs and LOCs associated with NACD applications,

there must be only ISDN route choices in the RLI.MAX 8.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 502 503

Comentários a estes Manuais

Sem comentários

HP Vectra 520 Guia de Instalação Página 55

Comentários a estes Manuais

Manuais e produtos relacionados com Barebones PC/estação de trabalho HP Vectra 520