HP Vectra 520 Guia de Instalação descarregar pdf (Página 73)

3-18 Hardware installation: Application Module (SNN/SNN-E)

553-4001-111 Standard 1.0 March 1997

Installing the Application Module

Procedure 3-1 details instructions on installing the Meridian MAX

Application Module as well as the MVME332XTS/XT and MVME167-34

or MVME 177-005 cards.

Procedure 3-1

To install the Application Module

1 Ensure the circuit breaker (CB) of the module in which you are installing

the power supply is in the off position.

2 Remove the front panel covering the AM cage.

Loosen the four screws at the front panel of the AM cage, and pull the

panel and attached cage away from the AEM.

3 Install the new Meridian MAX SNN/SNN-E Application Module into the

AEM.

Align the AM with the guides at the top and bottom of the AM cage of

the AEM, and slowly slide the AM into the AEM. Be careful to make

sure the cables and I/O panel are drawn through to the rear of the AEM

as the AM is being inserted. Tighten the four screws at the front of the

AM.

4 Connect the I/O panel to the I/O panel section at the rear of the AEM.

Line up the eight screw holes of the I/O panel with the eight screw

holes on the frame of the AEM. Connect the I/O panel to the AEM using

the eight screws.

5 Connect the NT7D55AD power cable at the rear of the AEM.

At the back of the column, locate the power cable running from socket

J8. Connect this cable to the P3 or P4 socket, which can be found

behind a metal plate behind the shelf’s main power circuit breakers.

The first module’s power cable connects to the P3 socket, and the

second module’s power cable connects to the P4 socket.

6 Connect the NT7D52AA Power Sensor Cable at the rear of the AEM.

Locate the Power Sensor Cable (two thin wires, yellow and grey, with a

small plug at the end). Connect it to the power monitor located at the

base of the AEM, between the two Application Modules.

Note:

It may be necessary to temporarily disconnect the cable

NT8D46AC and the PDU cable to make it easier to locate the correct

socket for connecting the Power Sensor Cable. Make sure that you

restore these cables to their original sockets after you have plugged in

the Power Sensor Cable.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 502 503

Sem comentários

HP Vectra 520 Guia de Instalação Página 73