HP Vectra 520 Guia de Instalação descarregar pdf (Página 446)

100

101

12-26 Workstation, HSL, and LML configuration

553-4001-111 Standard 1.0 March 1997

CDNO x

x must match the slot number on the Option 11 where the card is

located.

PORT x

The range for x is 0 to 1.

BPS 9600

USER HSL

Configure the user as HIGH SPEED LINK (HSL).

CUST xx

xx is the customer number. The range for xx is 0 to 99.

MGCR xx

xx is the number of call registers to be used for Meridian MAX. The

range for xx is 26 to 255.

Note:

Also in Overlay 17, the value of NCR (system call registers) must

be increased by the amount set for MGCR.

DCUS x

x is the number of customers; x must be greater than 0. Meridian MAX

can only serve one customer.

MAGT x

x is the number of agents that can be assigned on the Meridian 1. The

range is 1 to 1200.

4 Install the link. Refer to the document

Option 11 Installation Guide

(NTP 553-3011-210) for installation instructions.

5 If your system is a Meridian MAX - IPE/IPE-E, connect one end of the

High-Speed Link cable to Cable B, Port 8, on the Meridian MAX -

IPE/IPE-E, and the other end to the SDI card.

If your system is a Meridian MAX 8 SNN/SNN-E, connect one end of

the High-Speed Link cable to Cable A, Port 1, on the Meridian MAX,

and the other end to the SDI card.

6 Load Overlay program 48. Enter LD 48.

7 Enable the TTY port assigned to the High-Speed Link. Enter

ENL SDI HIGH

8 Enable the High-Speed Link. Enter

ENL HSL

telemanuals.com

1 2 ... 441 442 443 444 445 446 447 448 449 450 451 ... 502 503

Comentários a estes Manuais

Sem comentários

HP Vectra 520 Guia de Instalação Página 446

Comentários a estes Manuais

Manuais e produtos relacionados com Barebones PC/estação de trabalho HP Vectra 520