HP Vectra 520 Guia de Instalação descarregar pdf (Página 438)

100

101

12-18 Workstation, HSL, and LML configuration

553-4001-111 Standard 1.0 March 1997

11 Load Overlay program 48. Enter

LD 48

12 Enable the TTY port assigned to the High-Speed Link. Enter

ENL SDI HIGH

13 Enable the High-Speed Link. Enter

ENL HSL

14 Check the status of the High-Speed Link. Enter

STAT HSL

NRDY should be the system response. Immediately log out of the

Overlay and TTY or the link will not come up. When the link is up, the

TTY will display ADD000.

15 You have configured the High-Speed Link.

16 If your Meridian 1 switch is running X11 Release 18, configure the

Meridian 1 database for Meridian MAX. Use document

X11

Features

and Services

(NTP 553-3001-305) and the following guidelines. For

prompts not listed, press {ENTER} to select the default value. In the

configuration data block (Overlay program 17), define the following

values:

REQ

CHG

TYPE CFN

CFN is the configuration record.

17 ADAN

aaa TTY

The address x must be the same as the physical address set on the

SDI circuit pack. The value for aaa must be NEW or CHG (for example,

NEW TTY 2).

18 CTYP

xxxx

xxxx is the SDI card number. The possible values for x are SDI, SDI2,

SDI4, and XSDI.

19 DNUM x

DNUM is the device number printed automatically. The range for x is 0

to 15.

20 USER HSL

Configure the user as HIGH-SPEED LINK (HSL).

21 MGCR xx

is the number of call registers to be used for Meridian MAX. The

range for xx is 26 to 255. The recommended setting is 20 for IPE and

25 for SNN/SNN-E.

telemanuals.com

1 2 ... 433 434 435 436 437 438 439 440 441 442 443 ... 502 503

Comentários a estes Manuais

Sem comentários

HP Vectra 520 Guia de Instalação Página 438

Comentários a estes Manuais

Manuais e produtos relacionados com Barebones PC/estação de trabalho HP Vectra 520